Animal Pipes

Honda Pipes

Muffler Stacks

NEW - Ceramic Coated Pipes

• Available in both "S" or "C" Pipes

• 7/8 or 1"

• Pipes have tab for using a bracket on frame
  
  

Choose Your Pipe

• "S" or "C" pipe with or without mounting tab

• Without tab - you can use the Header Sleeve

• With tab - you can use the Header Wrap

• Without tab - cannot use a mounting bracket

• With tab - you can use the mounting bracket

SUPER FLOW HONDA PIPES

• Welded on flange.

• Dyno tested for maximum flow.

• All pipes have a flange with a "D" shaped hole that matches the "D" shaped exhaust port

•  A 7/8" pipe is recommended for the Honda 120 motor.

• A 1" pipe is recommended for the 160 motor 

• 7/8" & 1" pipes with wider bends and a shorter straight section are also available to better fit the NC, Bullrider and Fiser cars. 

Honda "S" Pipes

• 1 Pc Pipes in 7/8" or 1" available

• 2 Pc Pipes in 1" available 

• Designed to fit N/C and many other cars

• Slip on flange allows pipe to adjust to car.

• Flange is "D" shape to fit port

Honda Pipe Bracket
Pinch Style

• Pinch style requires min. clearance

• Slotted bracket adjusts with motor

• Pivot clamp fits all sizes of frame tubes
  3/4" to 1"

Slotted Pipe Bracket

• Use a tab welded on the frame

• Use with your own frame clamp

• See 2 pc steel clamps ---
       (listed under rear axles)
  

Header Wrap Tape

• Wrap your tailpipe to eliminate burns

• 2" Wide - priced per foot

• 7 ft is good for both the "C" pipe and the "S" pipe if wrapped 1/2 overlap

NEW -- Header  Sleeve

• Sleeve slips over pipe instead of wrapping around the pipe

• Header fabric is expandable 

• 7/8" Wrap will fit both 7/8 & 1" pipes with no tabs welded on

• 1 1/2" Wrap will fit pipes with a flange welded on the pipe.

• 2 ft should fit any pipe.